| Using the method of E-bike tester | |||||||||||||||||||||||||||||||||||||||||||||||||||||||
| Release date：2014-04-15 News sources： | |||||||||||||||||||||||||||||||||||||||||||||||||||||||
| brushless motor tester 1, motor Holzer quality detection: With the car Bao Tin seat and the motor Holzer line tin plug (butt, five string, motorcolours are red, black, yellow, green, blue), in addition to the Rossoneri must be properly connected to other can be connected, open the switch of the battery, the battery indicator lights, slowly along the forward direction of electric motor, can see the third rows of three LED lights ordered light out, such as one or two, three do not have or have not ordered bright, light out, is that Holzer has been damaged or motor internal line contact. (battery lamp light please replace the internal battery to test). 2, motor Holzer phase detection With the car Bao Tin seat and the motor Holzer line Tin Plug butt, red, black must be properly connected, turn on the power switch, slowly along the direction of rotation ofmotor vehicle in 6 position, by adjusting the motor Holzer blue, green, yellow lines andcar Bao matching, the third rows of Ha, Hb, Hc, LED indicator light does not conform totable A, B, C, D, E, F six stable state changes and recurring.
The "1" represents the lights bright "0" the lights go out Corresponding to the motor Holzer line Tin Plug docking repair treasure on the blue line Ha (Holzer a) green line corresponding to Hb (Holzer b), yellow line corresponding LED Hc (Holzer C), if the connection to adjust the blue green yellow wire and car Bao, third rows of LED indicator changes consistent with table 1 change, now remember motor three Holzer lines corresponding car Bao blue (Ha), green (Hb), yellow (Hc) three line color sequence, we can motor Holzer line, B, a C sequence. 3, the motor phase angle detection Table 1 shows 60 o motor with "111", "000" two states, and 120 o motor is not, only "010", "101" two kinds of state, so the brushless motor test three LED indicator appears bright, and destroy the motor is 60 o, otherwise 120 o motor. 4, the motor winding: Detection of motor winding without opening the battery switch, connected with the car motor Po three thick line, and then rotate the motor, can see fourth rows of XA (blue) and XB (green) and XC (yellow) three LED indicator lights and flashing is normal, if a, two a, three LED lights do not bright is the set of windings failure or poor contact, then short the motor three thick wire, electromagnetic resistance motor should be uniform, no blocking, disconnect the 3 thick line, positive inversion should also be no blocking phenomenon, such as positive and negative are judged as winding short circuit electromagnetic resistance. Two, the brushless controller and the phase angle detection: Detection of brushless controller does not need to open the garage Po battery switch, the controller of Holzer signal six hole socket and repair Bao controller Holzer tin plug is connected to the controller, yellow, green, blue three main line are respectively connected with the main line of the car Bao controller three yellow, green, blue crocodile clip the line, the other takes off plug the rotational speed signal line on the controller and tachometer connected, otherwise there may be fed film sound detection effect. At this time to open the electric switch switch power supply controller, the controller 5V indicating lamp should light up treasure, if not bright, then 5V power output controller failure, directly determine the controller bad. When rotating, car treasure monitoring controller six indicating lamps: The 120 ° controller indicating lamp should be according to the law of three on the road by two two tube flashing, to repeat. If not bright and a lamp has been bright not flicker or not according to the law of one by one to two two flashes can judge the controller failure. Then the connection controller Holzer signal from six hole socket and repair treasure again, rotating, such as the controller of six lights are not bright, it shows that the controller is 120 ° phase angle. The 60 ° controller indicating lamp which has two should not bright (i.e. a road tube), indicating lamp should be divided into two remaining on the tube one by one to two two flashes. If not bright and a light has been lit or not according to the law of one by one to two two flashes can judge the controller failure. Then the connection controller Holzer signal from six hole socket and repair treasure again, rotating, two lamp is not bright lights, it shows that the controller is 60 ° controller. According to the market with blocking protection controller, was not detected in the motor rotation state, the controller judgment for blocking, more than 3 seconds automatic cutting controller for motor phase power supply, to avoid burning motor, because the car Bao supplied is motor controller analog signals, not motor formal work, so the band blocking controller turn protection will stall misjudgment, make two two flashes are shorter, detection didn''t see car Bao six indicator changes, then slowly rotating the retest. Three, a brushless motor and brushless controller experience distribution function: Brushless motor and brushless controller has thirty-six kinds, of which 60 ° normal has a positive rotation and a reversal, 120 degrees normal has three forward and three reverse, used car treasure can make the connection more simple. 60 ° line: since the intermediate controller Holzer line socket 1 lines are generally for the B phase, we can first detect motor blue, green, yellow lines a, B, Holzer C sequence, the six color line plug b sequence inserted in the motor the Holzer line of 1 holes, a, C phase line both sides are respectively inserted in the B can be any sequence color line, the adjustment good butt plug and socket motor controller Holzer Holzer line, then rough line according to the following up to six times the method to find a correct. 120 ° motor and controller Holzer line without wiring, inserted directly on the line, coarse line according to the six connection to find a correct. The correct motor should be running smoothly, no noise, no load current does not exceed 1.2A. Such as the steering and need not, a stupid way: motor a, C on the Holzer line, thick lines and a maximum of six connected to steering, another line: Holzer a, C on A, B can transfer, main line. The six connection: The controller of coarse yellow and thick yellow, thick green motor controller and motor coarse green, blue and motor controller coarse coarse blue. The controller of coarse yellow and thick yellow, fine motor controller and motor thick blue, green blue and green motor controller coarse coarse. The controller of coarse yellow and green, green coarse coarse motor controller and motor coarse yellow, thick and thick blue blue motor controller. The controller and the yellow green, coarse coarse motor controller and motor coarse green coarse blue, blue and yellow motor controller coarse coarse. The controller and motor, coarse coarse yellow blue green and motor controller coarse coarse green, blue and yellow motor controller coarse coarse. The controller of coarse yellow and blue, coarse coarse green motor controller and motor coarse yellow, blue and green motor controller coarse coarse. Four, to the test: The measured rotary handle three lines | |||||||||||||||||||||||||||||||||||||||||||||||||||||||
| Previous：Using the method of detecting instrument motor controller Next：Nothing | |||||||||||||||||||||||||||||||||||||||||||||||||||||||
